Wanhao Duplicator i3 Plus Side Filament Guide

thingiverse

Intended for use with a PTFE tube, the filament guide can be rotated to fit your setup. The rotating section will lock into place once the part is secured. You might consider sanding it down or reducing its size slightly if you prefer a looser fit. I used four M3 x 16mm screws to attach it to my printer, being mindful of hardware selection to prevent screw heads from interfering with Z and X movement. The design is based on inches, specifically the i3 Plus. However, I'm unsure if this will accommodate other printers. The screw spacing forms a square measuring 1 3/16 inches. Please note that the model is in inches. Depending on your slicer settings, you may need to manually scale it to centimeters or accept an auto-scale prompt.