WANHAO Duplicator i3 - Z Braces With Feet v1.0

thingiverse

This is my personal remix of two things I wanted to add to my WDi3. Putting both those things at the same time on my printer would have been a little overloading. That's why I decided to combine them. I also added my little touch by adding a ball joint to the lock-nut located inside the front feet. This way, the braces can be set in a free state before squaring it. I added a support arm on the back brace to keep the heated bed wires from getting tangled on the Y-Axis bed, specially when the Y-Axis is at its YLarge Limit. I got the Level Foot from my local hardware store. I think Mal3D got his at Home Depot. These are cheap and allow you to level your printer on uneven surface. On my setup, I used lock-nut at all 8 points, just to make sure vibration wouldn't loosen up standard nuts.