Warhammer Bolt Gun with supports

prusaprinters

<p>This printed very well on my MK3S+ with PETG. &nbsp;Took a long time, but my kid likes it. &nbsp;</p><p>I cranked up the speed to 500% on the print and didn't notice any issues. &nbsp;However, keep in mind that the acceleration caused by the gyroid infill prevents the print from actually increasing in speed much. If you change the infill to rectilinear or grid, it would probably run a lot faster because the nozzle would have lots of straight lines that wouldn't be limited by curvature and the effects it has on acceleration.&nbsp;</p><p>3 areas to consider where the print had some slightly trouble that resulted in some minor surface distortions where you could add some extra supports there if you really care...</p><ol><li>The lips at the bottom (top back angled part) on the sides kinda stick out pretty wide for the printer to manage perfectly without supports. &nbsp;</li><li>The larger circular discs on the back of the sides also had minimal warping&nbsp;</li><li>Tthe area directly over the trigger. &nbsp;</li></ol>