Warlayer Sliding Doors

thingiverse

While I liked the sliding door that came with the warlayer kick-starter, I wanted the doors to be held by the actual wall. After a little tinkering I came up with the two piece door. I tried to copy the original style Andrew used in the creation of his files so that they wouldn't look too out of place. If this is accepted well I think I'll also make a single sliding door as well. Just like the original kick-starter these files do not need supports to print so just place them on the bed, possibly add brim, and go at it. To assemble the door, just make two doors, the top and the main body. then insert the doors in (they can each only go one way) and then push the top in with the groove facing down. Check to make sure the doors move as you'd like them and then if you want you can glue the top in place. This is still very much a work in progress so any other ideas or critiques are welcome. Hope yall enjoy these. UPDATE: 10/14/19 I noticed that the tolerance between the top and the main body was pretty tight so I went ahead and shaved off some. Its the mk2.1_updated file. If you are having trouble fitting the top in try using that instead.