Water Pipe w Quad Pull Matrix and Ice Cube Tray

thingiverse

Requires a 14mm bowl 3D PRINTING SETTINGS I used .25 layer height for all parts but of course you can print @ a higher resolution if you wish Retraction settings: Only retract when crossing open spaces Minimum Travel for retraction 6mm Perform retraction during wipe I did not use 'Avoid crossing outline for travel movements' as this for some reason doesn't print as well especially along the start line/seam. Select 'Choose start point closest to specific location' and rotate parts in your slicer until seam is down the back of the part(s) I find the bowl will leak eventually if it is not coated on the inside To coat the bowl: Varathane Diamond Wood Finish - Interior Water based poly - I think I paid $9.00 CDN For Food Safe, BPA free, 0 VOC you can use a product called Art Resin it's a tad more expensive to purchase. Assembly: Sand with 300 grit sandpaper just to rough up the contact points and use non toxic glue, I used Weldbond Adhesive, 420-mL. Sand the inside of the bowl as well before applying Coating