WaveShare 7" Touch Screen Case

thingiverse

A version 1.0 of a screen case for a 7" screen. It is intended to be mounted onto a printer frame and connected to a Raspberry Pi 3 for use as an "on-printer" computer. The screen will require: 4 M3/M4 5mm screws and nuts for the screen mounting. 4 M3/M4 12mm screws and nuts for the face cover mounting. 4 M3/M4 12mm screws and nuts for the back-plate mounting. A backplate (I used a small sheet of 2 mm aluminum cut to size and drilled holes for mounting). For version 2.0, -the screen width was either incorrect or the print was inaccurate. Decrease width of left vertical bar on faceplate. -the faceplate-body connectors need to be thinner to allow screen more room. -the screen mounting spaces need to be as thin as the faceplate-body connectors. -alter the HDMI and USB hole port for correct spacing. -adjust nut-trap sizes. These were either slightly too small or the print was inaccurate. -increase wall thickness by 0.5-1.0 mm to increase strength.