Wearable sanitizer bracelet

thingiverse

This is a remix. Because the original design was not shared, I had to redesign this model again completely by myself. This means that the idea and the workings are the same, the dimensions might not be. I did not have such a bottle cap lying around (as in the orignal design), so I decided to change this. The means of filling the bottle is now a small hole that can be sealed off by screwing in an M6 bolt. To my surprise the model was airtight already without any other form of sealant (tape etc.). Just screwing in the M6 bolt a bit was enough. I have used the pump of a perfume sample. This means that not the enitre bracelet had to be filled with alcohol, since the shorter hose could not reach it. This is why I separated the inside of the bracelet. The pump I used contained a coupling. I drew my model to match this. I have recently found out a lot of the perfume samples with the little pump use the same type of coupling. This model has been tested by a family member of mine which works in healthcare. This model is for the right hand, it can be made for the left hand by mirroring it in Cura. My family member preferred this so it would not interfere while writing. Because of debugging, I had to cut off a part. This can be seen in the picture. If all is well, this is not necessary. Described above is my share, I am now counting on you to finish this project for yourself! I sincerely hope that this model works for you as is. I love this idea, and hope that everyone can make it work for themselves. I hope that the only thing that has to be modified is the pump couplling or the dimensions for the arm. If you need the file in another format, please let me know! I hope to see awesome makes popping up soon! ;)