WFD100W Vase Mode Extension - Filament Drying

thingiverse

After carefully examining other extensions for the WFD100W and realizing that the estimated print time exceeded five hours, I deemed this utterly impractical. These designs are specifically intended to be printed in Vase mode with zero bottom shells in place. Running a 0.6mm nozzle on my print at 0.2lh yielded an hour-and-a-half printing time for ABS materials. A friend successfully tested this using a 0.4mm nozzle at 0.2lh, albeit with some minor issues. I strongly recommend utilizing a 0.6-1.0mm nozzle for printing these designs if possible. Three variations have been uploaded to the platform: Base, Double, and Triple, all of which should function correctly despite only the base variation being tested thoroughly. The measurements for each are as follows: * Base: 80mm tall * Double: 160mm tall * Triple: 240mm tall This product is designed specifically for use with the Westinghouse WFD100W Dehydrator, available on Amazon at https://amzn.to/2xivZ5c. You have the option to leave the stock shelves intact or remove the inner tray from all but one (for the bottom).