Wheel Balancing Inserts for Ducati Single-Sided Swingarm (S2R)

thingiverse

These inserts are for use in balancing rear wheels designed to fit the Ducati Monster S2R 1000. There are other models that use the same hub size, but I do not have a comprehensive list. If your Ducati has a single-sided swingarm with a hub post of approximately 48mm (at the base - they taper to the threaded end), these inserts should work for your rear wheel. !! YOU MUST USE YOUR STOCK OUTER CONE !! The outer insert is sized to fit snugly into the centering cone, which then will hold the wheel in place on the outside. The inner insert is sized to fit snugly into the wheel itself, so no other parts are necessary. The center holes in each insert are sized to fit a good distance up onto the balancer centering cones (20mm bore). I have only tested this with the Black Widow gravity balancer, but these should work with the BikeMaster, Park Tools, and Tusk balancers as well (pretty much any gravity balancer with reasonably-sized centering cones). Note on insert sizing: The dimensions of each .STL are approximately 0.5mm over, to accommodate materials that shrink a bit - PET-G, Nylon, etc. When using with PLA or other filaments that do not shrink after cooling, some sanding will be required (sanded PLA inserts pictured).