Wheel of Fortune - 42 slots using a 608 zz bearing

thingiverse

The Wheel of Fortune by Celian_31 works for my use case where I need a variable number of slots that cannot be determined ahead of time. With this model I would just print or write the number of notes I need then insert it at equal (or nearly equal) intervals. Items that were hit before can be removed while the spinning continues. My problem is that he uses a 30x10x9 bearing but all I have are the 608zz ones. 8mm x 22mm x 7mm. So I took the models to tinkercad real quick and made these. The only flaw is that the post and hole are still 9 mm deep so you will have some slack. Just make sure they match when you install them on. The holes and post are built using my printer's tolerance. You may need some scraping and sanding