Wheeled bumpers for Onewheel+ and Onewheel V1

thingiverse

These are bumpers made to attach 50mm luggage wheels. Put them on the back and add a handle to the front bumper to make it easy to roll the Onewheel like luggage, rather than carry it. It's easy to make a handle by doing something as simple as drilling holes in the front bumper and running paracord through the holes and a grip of some kind. Magnets can hold it to the bottom when not in use. These bumpers can also be added to the front to protect against nosedives. Keep in mind that wheels would only protect the rider from sudden deceleration caused by the bumper grinding against the ground. If the rider is not well balanced, the nose suddenly dropping out from under the front foot will cause a fall, whether there are wheels or not. These bumpers are part of a full kit available at [Carvepower](http://carvepower.com/) There are some narrow slots embedded in the sections that hold the wheels. These are thin enough that they will likely be filled in when printed. If you print with 6 perimeters, the perimeters around the slots will cause those sections to be solid without the need to print the entire bumper at 100% infill. Add [#10-32 heat inserts](https://www.mcmaster.com/#93365a154/=19t5ilk) to the blind holes for attaching the bumper.