Wheelie bar

grabcad

Description:Have you ever wanted to do a wheelie on a dirt bike? No? Good, you could have the potential risk of getting hurt. Now if you wanted to, you could use a wheelie bar.You could do a wheelie without the risk of falling backwards. The wheelie bar consists of two wheels that can have traction on off-road conditions, two large screws for the stability and security of the wheels, and 1 pole with 2 others holding the screws; these poles have a size relative to the bike. Instead of having only these two wheels to keep you from going backwards, I made a whole new set that will stop you from falling to the sides, and these wheels are connected by a small pole as to not shake back and forth.When doing a wheelie the risk of falling of the bike is in three directions, you could fall to the sides, and behind you. To prevent falling from the sides, the two wheels are attached to the left and right sides of the bike, and are long enough so that the wheels stop you when you are getting your front wheel too high. One of the problems I thought of is that when landing on the wheels if they are stiff they could snap or you could flip over the wheels. When designing the product I decided that it would be beneficial to make the poles that the wheels were on a little bendy, not enough to have no effect in keeping you upright, but enough so you don’t go over the wheels.