Wildberry Pi Case - Printable, Totally

thingiverse

My gift to you this Christmas season. With so many cases out there, it only makes sense to add another if it brings a lot more to offer. Here is the short list: Built-in clearances for putting the Pi in the oven. No sanding, or cutting. Just plop it in there. No weak, spindly protrusions that will break off next time the wind blows. Minimal use of plastic, but really strong. GPIO clearance, so it fits really nice. In fact, all** clearance issues that I have found in other designs has been addressed here. 5.Mounting holes, for permanent installations. Options for vents, and no vents. Stackable, and upwardly expandable. Less likely to warp during printing. Instructions The ribbing around the base, and the pads in the corners help to eliminate warping during print, by allowing some of the tension of cooling to relax. For best results, use a layer height of 0.35mm. It goes without saying that you should have a calibrated machine for this one.