Wind guide for HICTOP Desktop 3D Printer

thingiverse

UPDATE: Version 1.3 Honeycomb fan grill. Printed at .125mm resolution (if you go any higher than this the honeycomb may not turn out so great.) 100% infill (just my own preference) Printed with supports through CURA software. Support Type: I printed this with Touching Build plate only setting. (Note: This is probably the most important setting for a fan guide designed like this. If you print this with supports everywhere, you will have difficulty fishing the supports from inside the enclosure. I had no issues with sagging or warping on the outlet hole. Version 1.2 Here is a moderately modified Wind Guide for the HICTOP Desktop 3D Printer. I widened the inlet-outlet of the shroud. The base for mounting with screw holes has not been modified. I wanted more coverage area for cooling. I have found that I get less warping on corners and the overall print because of a more even cooling with this shroud. Printed at 0.125 resolution/layer height 100% infill Supports