Wingspan Bird Feeder Dice Tower Remix

thingiverse

Had a tough time printing the original without supports and mid print my tree support (from Cura) was knocked over, so I sought a better two part system. The original has a split version, but that leaves a necessary seam down the center of the birdhouse. I remixed the original and "cut out" the back panel with one baffle where the dice go in as well as the tabs the hug the tray/bottom. I recreated the back panel and reinforced it to not be so fragile. Now you can print both the front and the back panels flat on the surface without supports at all. Then super glue them together for a more seamless presentation. For some reason the notches on the bottom tray did not align with the size of the birdhouse, so I expanded them 1mm on each side for a better fit.