Wire chain for Sunhokey Prusa i4

thingiverse

This cable chain for Sunhokey Prusa i4 based on perfect A.N.Onymous link design: https://www.thingiverse.com/thing:666118 There are few changes made in original link design. - Link shaft was lengthened a bit for chain to be more solid. - Small support bars were added under shaft ends for better print quality. You will need to cut off supports before assembling a chain - First 10 of 23 links were adjusted to have stronger bending as print head in right upper position is too close to acrylic frame. I also created two end links. The first one is glued to the bottom of extruder stepper motor. The last is screwed to the right side of acrylic plate next to the frame. I’ve made a 10x10mm notch from the right side of acrylic plate instead of passing wires through hole so wire chain may be easily detached if needed. Please use SketchUp sources for adjustments