Wire Management for Small Wires

prusaprinters

<p>I needed small wire management in my 3D printer enclosure (<a href="https://www.thingiverse.com/thing:3319066">https://www.thingiverse.com/thing:3319066</a>) to add some lights. I would be using wires that are 1mm and 1.5mm in diameter. I could not find a design that would work for me, so I designed my own. The wires are held in neat rows with pegs that accommodate two wires stacked one on the other. It can hold 3 pairs of the 1.5mm wire and 2 pair of the 1mm wire. The sections can be fitted together end to end in any configuration. They are designed to be held down with either double-sided tape or as in my printer enclosure with #4 flat head screws (M3 flat head screws should work also). The 1mm wires go into the outside pin rows on either side (the white wire in the photo). I have yet to install these in the enclosure and if the heat in the enclosure heats the wires and softens them so they are no longer retained, I may have to design additional retaining for those that are vertical on the wall and those that are under the roof of the enclosure.</p> <h3>Print instructions</h3><p>Slicer Settings:<br/> I used Prusa Slicer 2.3 Beta for this with<br/> 0.30mm DRAFT default profile with 100% infill</p> <p>Printer and Filament<br/> Printed on a Prusa MK3s<br/> using Filastruder Veracity Black PETG</p>