WLToys 24438 ECX Temper 1/24 Crawler Articulation Fix

thingiverse

I designed these parts to fix the axle shift during articulation for the WLToys 24438 1/24th scale crawler. This fix reverses the triangulation of the lower links by replacing the lower transmission mount and swapping locations of different length ball ends. Instructions: 1. Print 1 of the Trans Mount parts and 4 of the Tiny Washers. 2. Remove the long ball ends from lower shock mount and the short ball ends from the lower axle mount. Install 1 Tiny Washer on each long ball ends and screw them into the lower axle mount in the same orientation as original short ball ends. 3. Install the short ball ends from lower axle mount into the newly printed Trans Mount, facing inwards instead of out. This step is a little difficult. I used a long ball end to thread the holes in the Trans Mount from the outside then installed the short ball ends in the holes. 4. Finally, move medium ball ends from the old transmission mount to lower shock mount position and reassemble everything.