Woman body optimised for vase mode

cults3d

Optimised version to be printed easily and faster in vase mode! Recommended settings for 0.4 mm nozzle: CURA: Special Modes -> Spiralize Outer Contour S3D: Layer -> Single outline (Vase Mode) Slic3r: Print setting -> Spiral vase NO SUPPORT! PS: Keep in mind that the most important factor to have better overhangs is the ratio between line width and layer height, LW / LH >= 5 50% size ( 30 minute): Layer height: = 0,10-0.11 mm Line width/Extrusion Width: 0.55* mm (minum) Speed: 30-40 mm/sec or slower (20 mm/sec Wall) Minimum layer time: 3s Temperature: +5C Fan: 100%* 100% size (90 minute): Layer height: 0.12 - 0.13 mm Line width/Extrusion Width: 0.65* mm (minum) Speed: 40-50 mm/sec or slower (25 mm/sec Wall) Minimum layer time: 8s Temperature: +10 C° Fan: 100%* 200% size (210 minute): Layer height: 0.15 - 0.16 mm Line width/Extrusion Width: 0.8 mm * (minum) Speed: 50-60 mm/sec or slower (30 mm/sec Wall) Minimum layer time: 16s Temperature: +15 C° Fan: 100%* Note: Yes, it is possible to change the width of the line, up to 0.8 mm even with a nozzle from 0.4 mm Fan: (PLA/PETG 100%, ABS 0%) Optimisations: Head cut at a greater angle for better overhang Slightly lower shoulders for better overhang Reduced pit above the clavicle Adding venetian dimples Most proportioned body Increased definition between the legs and the buttocks Fixed the hole between legs