Wooden Water Well 3D model

cgtrader

Dimension: 2136.96 x 1616.42 x 2406.29 Wells were built as follows: to begin with, a set of works was performed to find the optimal place for digging. Obviously, there was no corresponding ultrasound or x-ray equipment at that time. This means that people used the experience of their ancestors, their own intuition, certain knowledge and traditions; wooden poles were installed in a special way in the excavated mine. Since our ancestors did not know anything about the technology of production of reinforced concrete structures, and wood is very susceptible to rotting under the influence of water, piles were lubricated with special mixtures produced on the basis of natural derivatives; the Production of wooden load-bearing structures in the form of piles required a clear (up to centimeters) definition of the occurrence of aquifers. In this regard, any mistake could lead to almost fatal consequences; After driving the piles into the ground, the well shaft itself was equipped, works were performed on the drainage system equipment, the external design component was arranged in the form of a roof, a chain with a bucket, and a bench.