Work Light - Yellow

prusaprinters

<p>This portable yellow work light was sold on eBay and used three included 18650 batteries. The work light underperformed. This document describes a re-engineer of much of the work light. The rebuild makes it brighter and adapts it to work with Makita 18V LXT batteries.<br/> The rebuild elevates the light’s performance to a higher level and is finished with a 3D printed enclosure for the new electronics and the Makita battery fitting.</p> <p>To make the work light brighter, I replaced the original LED module with a low cost 50W COB LED module. This new COB needed to work with my Makita 18V LXT battery, so new electronics were integrated into the design.</p> <p>Where the site allows, for those interested in part or all the workings, I've included a document describing the design and wiring.</p> <p>My print is made in PETG 1.75mm 3DFillies orange filament, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.</p> <p>I hope you can find this design useful, too.</p> <p>Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.</p> <h3>Print instructions</h3><p>My print is made in PETG 1.75mm 3DFillies orange filament, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.</p>