Workshop top (Lars homestead)

prusaprinters

<p>The top of the workshop on Lars homestead that can be seen on the surface.&nbsp;</p><p>You need to print 4 of both the top and bottom sections. I only used supports under the connector pins. Once printed I glued the sections together, filled any gaps, put some sand on the surface (to give a corroded look) and then painted it.</p><p>You should be aware these files are an absolute mess! I have got them all to slice in PrusaSlicer but can't say for others slicers. If you want to modify them you would probably be better to just start afresh.</p><p>This is part of a larger project where I built Lars homestead as a backdrop for photos of a Lego landspeeder. The other parts of the project can be found below:</p><p>Entry dome - <a href="https://www.prusaprinters.org/prints/98051-entry-dome-lars-homestead">https://www.prusaprinters.org/prints/98051-entry-dome-lars-homestead</a>&nbsp;</p><p>Droids - <a href="https://www.prusaprinters.org/prints/98160-eg-6-and-wed-15-droids-lars-homestead ">https://www.prusaprinters.org/prints/98160-eg-6-and-wed-15-droids-lars-homestead&nbsp;</a></p><p>Vaporators - <a href="https://www.prusaprinters.org/prints/98157-vaporators-lars-homestead ">https://www.prusaprinters.org/prints/98157-vaporators-lars-homestead&nbsp;</a></p><p>Assorted props - <a href="https://www.prusaprinters.org/prints/98303-mixed-props-lars-homestead">https://www.prusaprinters.org/prints/98303-mixed-props-lars-homestead</a></p><p>The pit - <a href="https://www.prusaprinters.org/prints/98353-the-pit-lars-homestead ">https://www.prusaprinters.org/prints/98353-the-pit-lars-homestead&nbsp;</a></p><p>Key ring - <a href="https://www.prusaprinters.org/prints/98203-stormtrooper-keyring">https://www.prusaprinters.org/prints/98203-stormtrooper-keyring</a></p><p>Project video -&nbsp;</p><figure class="media"><oembed url="https://youtu.be/4DrqN3uXsQk"></oembed></figure><p>&nbsp;</p>