World of Warcraft - Ashkandi

thingiverse

This sword is inspired by Ashkandi from World of Warcraft. It is not completely accurate but should be close enough to be recognizable. **This model is a work in progress. I'm currently printing it and will remove this disclaimer when I've successfully finished it.** The model was created using Blender 2.8 and took just above 60 hours to complete. Since the sword is almost 2 meters long it is cut into smaller pieces that should fit most printers.There is an upper side and a lower side so the pieces can be printed lying flat and needing minimal amount of support. To put it together the pieces feature either little holes for dowels or are cut like puzzle pieces. It also has room for a wooden core that is 1.5 meters long and 28mm in diameter. In total 104 dowels will be needed.