Wowstick Flat Case

thingiverse

A Wowstick 1F+ holder, with space for 40 bits. (A bit wider than the original case, but also flatter and less-long.) Uses four 4x2mm disc magnets to hold the halves together. Printed with 0.2 layer height. - Screwdriver fit is proper, though test with was with an earlier iteration. - Hexbits fit is a little tight, but loosens with a few insertions. Will update this from WIP to real (with pictures) once I'm done tinkering: - Do fingers fit to pull bits out? (Need to lengthen the case? - Magnet fit and strength? (Need stronger/bigger magnets?) - Screwdriver fit w/ halves? (Increase height tolerance?) - Print-in-Place Hinge? (How annoying are bits?) 2021-07-09 -- Added a different variant (wsr_*) that uses a removable bit holder. This should allow for easier manipulation of the bits, and also makes the case even smaller. [Not Yet Printed; above testing list still applies...]