Wrist lap counter

thingiverse

The base has been remixed to be able to attach a standard 20mm watch strap to it. The top has been remixed to fill the hole, because I did not like the look of it when you could see the base. This should be printed in *150 microns or less* to get a nice top layer (the fill layer is very thin) My girlfriend swims a lot, and also listens to audiobooks while swimming - and it is difficult to keep track of how many laps you swim while listening to audiobook at the same time, so I figured this might be a simple and cheap solution. To print this, you also need to print the springs (2x) and the counter wheels (1x large, 1x small) from the original project. I would suggest using the v2 versions. (it has not been water tested yet :) )