WV Rear Wipercap (Passat B4)

thingiverse

The plastic cap for the rear wiper arm of a Passat B4 (I belive it's the same for other VW cars of the same era). Original part number: 333 955 435A This is the part number stamped on my original unit, strangely enough this seems to be for a slightly different model and the correct part number is "3A0 955 435". Why? who knows, maybe they changed the part numbers at some point. Either way they seem to be discontinued at most online shops and what little I could find was unreasonably expensive for a small piece of plastic. Anyway the piece is modelled by me in blender, taking measurements from the original, not perfect but pretty close. Also, it's tricky to install without the plastic cracking but good luck. / Print Settings: Printed on an Ender3-Pro Rafts: Doesn't Matter Supports: Yes I printed right side up with tree supports, can also be printed upside down for less support material and faster print time. Cura's Ironing feature helps a lot to get a smooth upper surface. Print time: About 2h 45min printing upside down @ .12mm resolution Resolution: 0.12mm (can be printed at other resolutions but this gives the best results) Infill: 100% (should be regardless of settings since the walls are only 1mm thick) Filament: PLA