WW1 fighter planes for microarmor

thingiverse

series of WW1 planes for microarmor they seem to print very nice with resin printers ( danke schoen dt118 ! ) for FDM, just try to orient the model so the struts are at a 45 degree angle to avoid supports on them I'm just tossing these up as I do them model in full dimensions in blender 2.82 and exported from blender 2.79b* at 1/100 for the .stl file scale down to 35% in the slicer. I've had issues exporting .stl's from 2.82 for Cura; 2.79b and 2.80 export the same mesh to different file sizes, too. So I export the mesh from 2.79b for consistency's sake. no test print because I'm very lazy and these are very difficult to clean up with damage ( struts are often only .5mm thick ) I'll probably print these at 1/200 scale Albatros D.2 w/ side radiators Albatros D.2 w/ wing radiator Albatros D.3 ( D.5 & D.5a has a slightly different fuselage, but likely not noticeable at these sizes ) Sopwith Tripe Sopwith Pup Sopwith Dolphin Sopwith Camel Fokker D.6 Fokker E.5 ( D8 ) Fokker Dr.1 Fokker D.7 Fokker E.III SE5a Nieuport_17 Nieuport_28 Pfalz D.III Pfalz D.IIIa Halberstadt D.II Airco DH-2 SPAD 13 *** fixed the top wing of the Fokker D7 ( 04Mar21 )