X carriage all in one for e3d v6 and bulldog ,for long Alu/Printed blocks.

youmagine

I replaced my original 2 x-axis bearings with 2 in 1 aluminum blocks. I've also added a printable version instead of using the aluminum block - that design isn't mine, though. This carriage is designed to work seamlessly with bulldog extruders like the E3D V6 and an inductive sensor. The alignment of the x-axis turns out perfectly with this setup; you can attach the blocks directly onto your smooth rods, then secure the carriage tightly so it won't bind at all. To fit the inductive sensor under the motor, I created a custom adapter between the E3D V6 and the bulldog extruder. It works best when a Teflon tube is inserted into it. You'll need 2 regular clamps for the bowden setup, as well as 1 regular clamp and 1 low clamp for the direct version. I adjusted the belt holders' heights because the Mendelmax 1.5 uses larger bearings that cause the belt to sag on one side. This modification ensures the belt stays parallel as it travels. If you'd like, I can provide some photos of my creation.