X Carriage for Igus Pillow Block Bearings with Rear Fan Mount

thingiverse

Inspired by the Pillow Block X-Carriage by AlephObjects - this is an X-carriage designed to be used with Igus Pillow Block Bearings, with room for an extruder fan mount on the rear of the carriage. I specifically use this X carriage on MendelMax 1.5 printers. Instructions Simply download, print, and enjoy. Depending on the calibration of your printer, the holes for the nut capture may be tight - if so, the easiest way to get the nuts where they need to be is to stick a screw through the hole, stick the nut on the end, and tighten until the nut is all the way seated in the nut capture hole. Then remove the screw and continue with the process until all of the captured nuts are in place, then install your new X carriage.