X-Carve Y axis dust covers with brushes

thingiverse

This is a remix of deweycox remix of phraust Y-Axis Motor Covers. Deweycox mods: Alternate magnet type Front and Rear V-Track brushes that will keep the v-track clear of debris. Adjusted height to work with Y-Axis Stiffeners. My Changes: Magnet towers are now integrated into the side wall allowing for continuous printing without lifting hot end to re position. I also made the magnet towers 1.2 mm thick allowing for 3 layer walls using a .4mm tip. It uses 18 mm diameter magnets that are 5 mm thick you can buy at Lowes, Home Depot, or amazon. The brush is 1 inch brush strip from McMaster Carr. Same brush used for the Suckit Dust boot.