x-lite faceplate

thingiverse

Protective travel plate for FrSky x-lite. The gimbal holes are 15mm so they will fit the larger gimbal stick ends, like the ones I have previously made but should also be fine with standard ones. I've made this because I run 18650 batteries so the x-lite no longer fits in its case. Printed with 100% infill, supports 10% everywhere, PLA temp 210C bed temp 60C. And dropped the speed down to 50mm/s and part cooling fan I dropped down to 50% for better layer adhesion = better strength. The part is slightly larger than needs to be so you can put sticky foam on the inside to prevent the radio from being scratched by the faceplate. Also printed the right way up to give the face the best finish. There is lots of supports so there is a bit of cleanup but best result