X-One 2 Glass Holder Test model 3

thingiverse

Couldn't find something that would hold the glass still for the X-one2 because of its surrounded platform raised lips. I did find one on here, but it seemed to over complicate the idea I was looking for and had the potential to damage the machine. Please note this is a test run of the 3rd attempt. Printing with 100 infill .2 layer height .3mm walls cubic pattern PLA (as that's the only thing I currently have) I've read it's better to run a more heat rated material for these, but I don't currently have any so this is what's happening right now. The two in the front will go where the hex screws with the springs come down under the hot plate. (You'll need a 2 hex key to remove, and a small pair of pliers or deep socket) Twist the spring and it'll come off the nut. Twist it back while applying slight force to put it back on. Two in the back to the far right and left sides. The screw seems too short on there, but it will actually work and tighten down. Note when reinstalling you will have to tighten the bed all the way down, as there isn't much room left with the stock springs after adding this. So before you actually level it, go as far down as you can.