Distance, Time and Force equations

prusaprinters

<p>These are just some equations for distance, time and force. I have not printed them but they should be good. I had to scale them in Cura to 70% to fit on a cr10 (8 x 0.2mm layers) and 60% should work for an Ender3 size printer (7 x 0.2mm layers). If you need them thicker you can scale the X and Y only and leave the Z at 100% which will be 3mm tall by default. There are 2 versions of the distance equation one with "s = " and the other with "d = ".</p> <p>I will post some pics whenever I print them, but am too busy right now. I had planned on printing them in the orientation shown, then when they are done, lay down some masking tape to hold them in place while they are removed from the bed. Then I would probably hit them with some spay glue or just rubber cement and finally stick them to the wall (noting that any glue on a wall is gonna more or less be permanent and will probably take the paint off when removed).</p> <p>I may do some more of these, but my app crashed while I was working on some for Ohms Law, RC time constant, Coulomb's Law and the resistor and capacitor series / parallel equations, and the resistor divider formula .. and I lost all the work ( I should do one on Murphy's Law too I guess ). If there is any interest I may try again to make some more.</p> Category: Physics & Astronomy