x2 / harbor frieght mini mill cnc stepper covers and fan cover

thingiverse

when enclosing a mini mill and using flood coolant you need a way to cover the steppers so water isn't pouring all over them.... here is a x,y,and z stepper cover for nema 23 steppers... these are designed around the fusion cnc kit for the x2 or harbor freight mini mill... I also included a file for the electronics fan cover so if you are using mist or have a lot of water slinging the fan wont suck up water being open like it is from the factory... install the fan cover with the opening towards the back of the enclosure... you will need to drill and tap the stepper motor mounts to install these... can use m3 or m4 screws... also apply a sealant where the x and y covers are bolted to keep water from creeping under them .... the z motor cover needs no sealant and does not bolt on it just slides over the stepper and is snug for a no rattle fit... an extrusion was desined into this cover for the wires to pass through, just line up the wires in the notch and slide it down onto the motor... enjoy