X5SA BTT Manta M5P Electronics Case

thingiverse

Fixed the issues with the left box, everything should line up much better than the originals. Only use the v3.1 left & right boxes. If you don't want to use the breakout box, use the Left (Stock Bed) and the Center v3.1. The breakout board mounts to the side of the center box. Took the X5SA case that was designed for a Duet2 motherboard, and changed it to work with a BTT Manta M5P board. Since I'm also putting a hex skirt around the bottom with feet, I flipped the box so it mounts from the top of the 2020 rails, instead of the bottom. Everything should still fit according to my measurements. I just started printing the parts, so I'll report back once it's complete and post my results. This is very much a 'work in progress', so do with it as you will, lol. The breakout box part is for one of the ribbon cable breakout boards, and attaches to the 'top' of the left side box at the back. Breakout board: https://www.ebay.com/itm/362934689650 The (Stock Bed) parts are for the standard X5SA bed, with the cable chain on the left. The original part had the breakout bar box in the way of the cable chain mount on the bed. Moved it to the center box to clear that mount. If you're using a non-stock bed plate with the wiring for the bed in the center, you can use the alternate parts.