X8R Antenna Mount for F450

prusaprinters

<p>2 Antenna mounts made for the DJI F450, but I am sure it also fits other frames just fine.</p> <p>I've mounted them like recommended from frsky in a 90° angle to each other.</p> <p>Made different versions for each one</p> <ul> <li>for a m2,5 or m3 thread insert</li> <li>Screw in m2,5 directly</li> <li>Screw in m3 directly</li> <li>through hole for m3</li> </ul> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Ultimaker</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ultimaker 2</p></div> <p><strong>Rafts:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0,15</p></div> <p><strong>Notes:</strong></p> <p>I used rafts for the flat one because it was printed with the smaller side on the bottom, I thought it would fall over because of the little area that sticks to the plate.</p> <p>The thin walls are 1,2mm thick so best way is to print with 0,6 or 0,4 nozzle (resulting in no infill)</p> </p></p> Category: R/C Vehicles