Xbox and DVD Display Mount

thingiverse

Modified from the original holders that I currently have mounted, these balancing act holders allow for easy access for your games along the wall surface. This design was originally created to be mounted inside a closet, above the door frame to allow for concealment from the outside of the closet and a clear viewing of the games I currently play when I turn my head up in a direction not normally looked at in a small closet. If your printing with a 0.4mm nozzle, I recommend a test print to fit the case to make sur its not to tight. Your case should be able to fall out if you orient it straight up and down in the holder. The case should set in without scratching it by too much tension. If the holder is to snug, upscaling the model is necessary. Each hole template has a wedge piece for holding against the bottom of your level for a correct orientation.