XBox One S Contoller Stand

thingiverse

This is a XBox One S Contoller Stand I designed for my computer sidewall which allows to hang the wire. I advise you to print it in two parts, then gluing them with epoxy for more strength. You can use toothpick for a better alignment (after having drilled a hole at the good diameter). I gor some warping during th print, so I made a 7mm spacer to fit perfectly. It doesn't affect the ability to support the controller (it's even better...). I put the two parts *_ext3p5 with the half spacer already added on each side. As usual, the Fusion 360 file is available.