XHover GapIt GoPro HERO5 Session Mount

thingiverse

This is a 30-degree GoPro HERO5 Session mount for the XHover GapIt frame, intended for TPU. The camera opening allows the use of the Superview camera setting without the mount showing in the footage. I print mine at 25% infill. It is designed to be printed on its side (there is a tiny little flat spot on the side of the base by the back screw hole, put this against the bed). I do supports under the entire enclosure since the base sticks out further than the frame. I also support in the main lens opening. Support on the large button hole is not necessary if you have good bridging and a layer fan, but it doesn't hurt. Support is not needed in the back button opening. This is a 100% original design, not derived from any other. I have tested and refined it to my liking.