Xilo Phreakstyle Parts

thingiverse

These parts fit a Xilo Phreakstyle (30mm height) and the Slammed (20mm height) quadcopter frame. The mounting holes for the GoPro Hero7 need washers as they are slightly oversized to make assembly easier, and it's TPU so you should have a washer anyway. This was made in Tinkercad so only the STL is available. The Cam Mount tabs are to allow a Micro cam instead of a nano size. The tabs are centered but the hole is slightly offset to allow for camera rotation easier. The 8mm height fits in the carbon side plate spacing on the SLAMMED version. The rear mount has a hole spacing of 31.6 mm, center to center, so it may fit other frames as well. It is designed for a TBS SMA mount with threaded side holes, and a Crossfire Immortal T antenna at the rear. The curve in the top of the mount will allow you to extend your power leads out the back of the carbon frame and ziptie it to the top plate for strain relief. Besides the STL files there are also F3D files for Fusion360 if you want to adjust for your own uses.