XL5 Nazgul V5 motor wire protector

thingiverse

This motor wire protector for FPV quadcopters is a remix of https://www.thingiverse.com/thing:3540827 The original protector was too wide and a bit too short for the XL5 V5.1 frame (Nazgul v5). I scaled it to fit the XL5 in blender. While I was at it, I also scaled the optional bumpers to go beneath. I did not use these for the intended use but to suport and protect my crossfire immortal T antenna (see picture 2) together with my remix of a bottom mount for the antenna (https://www.thingiverse.com/thing:5254646). Prints easily standing up tall (not flat as shown in the thingiview) with a rather wide brim. I used eSun TPU on an Artillery Genius Pro, 100% infill, 1mm layer heigth and printed really slow for what I usually can do with this printer (15mm/s instead of 30mm/s). If I went faster, the sides that touch the XL5 frame distorted horibly.