Xmax V3 Pro Funnel

thingiverse

Funnel for Xmax V3 Pro vape and generic 1.5" 4 piece grinder To use, take top 2 compartments off grinder, set into fat end of funnel, should fit inside completely. Then, put narrow end into oven, retract slowly to ensure a complete as possible fill. Files besides funnel are included as gauges, do not need to print, just couldn't find them online anywhere so I uploaded the dimensions of my particular vape, ymmv if you have another one, but they should be relatively close, measured with cheap calipers to about 5 thou and plenty of tolerance included in design. If you have the means, you can measure your own and double check against my gauges, then modify as required if the two do not match. Would recommend printing out of ABS or something else with chemical/heat resistance better than PLA, don't want to melt or gunk up your funnel. Note: As of v1 have not printed this yet, will update if needs a redesign, oven end may be slightly too thin to hold up grinder, would not recommend being too wild with it while supporting grinder weight if redesign is not submitted.