xray M18 front spiltter

thingiverse

I've had my Xray M18 for a long time and use it to drift but it was lacking visually so I created some styling upgrades. this is a front splitter that fits on to the original front bumper section. the location holes slot on to the body posts. when printing have the recessed area (bottom) on the print bed. this will need support but as this will sit over the original bumper it does not matter if the print comes out a bit rough here. (it will be hidden) I printed it at 0.15 layers and came out rather nicely. the model as been changed as I had to trim my bumper to get it to fit but this should not be necessary as I've allowed for clearance. (message me if it does not fit) I've also added some cut outs to allow clearance for the front wheels. the original was fine but it was a bit close. note: you may have to trim your body shell in order to fit this. I trimmed about 2mm from the front of mine to get it to look right.