XT-90S (Female) Holder - Loop Key for Electric Skateboard

thingiverse

This is an XT-90S Female side, clamp style holder for electric skateboard loop keys. Its a semi-tight press fit when not tightened down, but once tightened down your XT-90S won't be going anywhere. There is just enough room with a bit extra for your XT-90 male connector to plug in, with a slight 5 degree angle so it's easier to grab and pull out. Made this out of Nylon. Uses 1x M4 nut, 1x M4 bolt, and two wood screws screwed into pilot holes on the deck. Check the size to make sure your wood screws fit, not sure what sized I used... but anything around 8-10mm thread in length, head diameter less than 8mm, and thread diameter less than 4 (ideally 3.5mm or less unless using semi-flexible filament like nylon) should work fine.