XUAV Clouds Flight Controller Shelf

thingiverse

This is a FC Mount plate for the XUAV Clouds that allows clean cabling around the FC and easy access to the SD Card as well as USB. The cables can be routed through the openings around the FC and with a bit of excess wire it allows you to lift the FC to access the cable compartment underneath it. the mounting holes are spaced to fit this FC Mount for Matek F765 Wing or H743 Wing FC. But you can also glue on every other FC mount or the FC directly to the plate. https://www.thingiverse.com/thing:4684636 make sure the hinge part and restraint part is perfectly centered and properly glued to the wall. Mut them all the way down to the bottom of the bay to have the FC perfectly level with the fuselage and have enough clearance for the electronic connections. Use M3 screws to make the hinge before gluing it in. Otherwise the screws are hard to reach. Also use short M3 screws to fix the plate in place. You can screw them directly into the plastic. A bit of foam trimming is needed on the edges of the cover restraints on the side to properly lift and lower the plate. If you solder all cables directly to the FC then you can lift the FC up by 20mm (use something as a spacer) and no foam trimming is needed. Can be printed without support.