XVico X3 Y-Stop spacer

thingiverse

The XVico X3 is a decent enough printer, but it has a strange design flaw - the Y-Stop is about 10mm off from where it needs to be and there's no built in way to adjust it. Most of the time this just means your prints are a little nearer the front of the bed that they should be, but if you're printing something that fills the bed, then you not only loose the bottom 10mm but you can end up printing off the bed at the other. This is a simple spacer that pushes over the tag on the print bed that's supposed to trip the mico-switch, and extends it by about 10mm, so now you can use the full 210mm of printable space.