XY JOINER for GT2 16T Timing Pulleys | 10mm and 8mm Shaft Clamp | HYPERCUBE

thingiverse

This is a redesign of the original Hypercube XY Joiner with a few changes: Mounting Position for 16T Pulleys: Less overhang, stiffer design Grooves for M3 nuts for easier assembly, inspired by arturslab:http://www.thingiverse.com/thing:2013475 This design will only work if you also use an Idler for Pulleys:http://www.thingiverse.com/thing:2186358 It will not work with a twisted Belt from the original design. The Area where the belt passes through the joiner is in this design smaller. If you want to change all the bearings to pulleys you need: 2x This XY Joiner 2 x New corner idlers: http://www.thingiverse.com/thing:2186358 6 x 16T pulleys with teeth 2 x 16T pulleys without teeth !!!WARNING!!! Be carefull if you buy your idlers. 5 of my 6 ordered pulleys from Banggood where not drill concentric and have an unbalance! The Idlers from Banggood are also very expensive. Try to get them cheaper and in a bigger quantity. For example from Aliexpress:https://www.aliexpress.com/item/3D-Printer-Parts-Idler-Pulley-Ptfe-Tube-for-20161030-01/32759898481.html 20.03.17: New version with more improvements and also a version for 8mm x-axis rods 14.04.19: I am not using this design on my printer anymore. Instead I am using my more rigid design with longer clamps that you can find here: https://www.thingiverse.com/thing:2192301 Print Settings Printer: Hypercube Rafts: No Supports: No Resolution: 0.2 Infill: 30%