XY-T01 Electronic Temperature Controller Case

thingiverse

This is a temperature controller case for the XY-T01 Electronic Temperature Controller found on Amazon (https://www.amazon.com/dp/B08PFJR6JY/) It's a tight fit and so may not even require the M3*6 screws to mount it. Be sure to slip the temperature probe connector through the opening FIRST before installing the temperature control board, otherwise it will be fairly difficult to get the connector in afterwards. The by-4 screw power/relay terminal opening is slightly larger and offset to allow the temperature probe wire (to the left) through. **UPDATE 08/19/2021** - I incorporated tabs in my version 2 design as I've found the friction fit lid may become loose over time **UPDATE 08/25/2021** - building on version 2, version 3 is 2mm taller to accommodate the mounting options that are incorporated at the bottom of the case (zip/nylon ties and/or M3 screws). **UPDATE 08/27/2021** - made a v3 lid for buttons; symbols are used instead of text for the different button functions as the text is hard to print/decipher once printed. Also, the display cut-out has been slightly adjusted **UPDATE 09/07/2021** - made a v3.1 lid for buttons; same as v3, however, the inside ledge corners have been notched to allow for M3 screw heads when used to mount controller in case. Inside ledge has been thinned by 0.1mm on both the longer of the 3 sides to prevent case sides from bulging when installed due to some printer tolerances.