XYZ da Vinci 1.0 Pro E3D V6 Drop-In Cartridge Mount - Enhanced Cooling

thingiverse

This is a somewhat hacked-up re-mix of the body of bdwalker1's "XYZ da Vinci 1.0 Pro E3D V6 Drop-In Cartridge Mount" to make it hopefully cool the E3D hotend better. I closed some gaps that let cooling air escape where it shouldn't, opened up the 'channel' to let more air flow to the bottom, and partially blocked the top part of the heatsink to hopefully re-direct the air primarily to the bottom of the heatsink, where it's critical. V2 revision created This version should be printable without supports, given a low enough layer height (0.2mm) *NOTE* These are thus far UNTESTED by me as I don't have my DaVinci modded at this time, but it should cool the hotend properly and prevent heat creep, which causes clogging. See bdwalker1's thing for the instructions and clamp and fan shroud: http://www.thingiverse.com/thing:1328848 Print Settings Printer: Any Rafts: Doesn't Matter Supports: Yes Resolution: 0.2mm height / 0.mm nozzle Infill: 15% Honeycomb Notes: See bdwalker1's thing for the instructions and clamp and fan shroud:http://www.thingiverse.com/thing:1328848