Y Axis End Switch Mount for 3DFused Upgrade CR10 SMART

thingiverse

5/15/23 PLEASE READ Chris Carlton found that 3dfused is shipping the Y axis with the bottom bed bracket mounted backwards. His video is here: https://www.facebook.com/1504669535/videos/6406697672723843/ I have not yet turned my bed around, so I have not tested yet, but I think this holder will work the bed turned around. I expect it would be mounted the same but using the alternate hole set in the holder when mounting. 5/16/23 I have turned my bed around as Chris suggested, and the switch mount works in that configuration. See the picture with the closer look at the switch mounted on the printer. It shows with silver tape where the switch mount was before rotation of the bed and now after rotation. After bed rotation the Y belt no longer drags on Y belt capture bracket. The rotated bed has the flatter side of the bottom bed bracket towards the rear of the printer, see Chris's video. Y-AXIS STOP SWITCH Mount (for at least the Smart and Smart Pro). I could not figure out how to use the 3DFused included Y axis stop mount, printed my own. Uses 2 M5x12 screws with nuts. Will also need to open the bottom and route the wire more direct to reach the Y axis motor and switch. Need to adjust the stop switch to stop the bed at the right position.